All products Structural sections · built to order

Angle Steel and Profile Shot Blasting Machine

Angle, channel and flat bar have a property that plate does not: two or three faces at an angle to each other, and a corner where they meet. A single wheel above the line cleans the top face and leaves the inner corner short — which is where coating fails first.

Why profiles need a different arrangement

On a plate you blast one surface and you are done. On an angle you have the two outer faces, the inside corner, and the ends. Wheels are therefore arranged above and below the pass line, and the workpiece is turned or the line is arranged so the inner faces see the stream too. That geometry, not the tonnage, is what separates a profile machine from a plate machine.

The same reasoning applies to scale: mill scale sits tightest in the corners and in the root of the angle, so the pass that cleans the flats can still leave it there. If your specification is SA 2.5 for painting or galvanising, the acceptance check belongs in the corner, not on the face.

Where it sits in the line

A profile machine is a through-feed line: sections come in on a roller conveyor, pass through the chamber at a set speed, and leave ready for the next station — cutting, drilling, painting or galvanising. Because the sections are long, the infeed and outfeed length is usually the constraint on the building, not the machine itself.

What sets the specification

  • Section size range — the largest angle leg and the smallest, which sets the pass line and the roller spacing.
  • Length and handling — how long the sections are and whether they arrive as single pieces or bundles.
  • Surface standard — SA 2.5 against SA 3.0 changes speed, and speed changes line length.
  • Throughput in tonnes per shift — with section size, this is what sets conveyor speed and wheel count.

Questions buyers ask

Can the same line do angle and flat bar?
Usually yes, within the roller span. What changes is the guide setting and sometimes the wheel angles.
How is the inner corner reached?
By arranging wheels below and to the side of the pass line, and in some layouts by turning the section. It is a layout decision made at quotation, not a setting on the machine.
What do you need to quote?
Section types and sizes, lengths, tonnes per shift, and the standard the coating requires.

Related: roller conveyor machines for plate and H-beams, which machine type fits your part.

Send the section schedule

Sizes, lengths and tonnes per shift — we will size the pass line and the wheel arrangement.

Get a quote

Related machines

Buyers weighing this machine usually compare it against these.