All products Pipeline coating prep · built to order

Steel Pipe Internal and External Shot Blasting

A pipe is two surfaces with one wall between them, and they need different machines. The outside is blasted while the pipe turns on rollers. The inside is blasted by a lance that travels down the bore. Coating specifications — 3PE, FBE, epoxy — care about both.

External: the pipe turns, the wheels stay put

The pipe sits on powered rollers and rotates while blast wheels above and below clean the circumference. Rotation is what makes it a continuous process: the wheels do not have to reach around the pipe, the pipe brings each part of its surface to the stream.

The variables that matter are the pipe diameter and wall thickness (thin wall distorts if the rollers and the blast pressure are wrong), the length, and the grade — a line coating for atmospheric service and a pipeline coating to SA 3.0 are not the same job at the same speed.

Internal: a lance, not a cabinet

Internal blasting uses a rotating lance that is driven into the bore and withdrawn at a controlled rate. Coverage comes from the lance head pattern multiplied by travel speed; the operator sets the pass, and the machine keeps it repeatable down the length of the pipe.

This is where most internal coating failures start. A bore that is clean at the ends and dull in the middle is a travel-speed problem, not a media problem — and it is invisible until the coating fails in service. Which is why the acceptance check belongs inside the pipe, not at the ends.

The combined line

Where both surfaces are coated — the usual case for line pipe — the two operations are built as one line: load, external blast, transfer, internal blast, inspection, coating. Handling between the two stations is where layout decisions are made, and where most of the civil work sits.

What sets the specification

  • Diameter range and length — one machine can cover a range, but the extremes set the roller centres and the lance stroke.
  • Wall thickness — thin wall needs gentler handling and a different roller arrangement.
  • Coating standard and throughput — SA 2.5 versus SA 3.0 changes cycle time, and cycle time times pipe length sets the line length.
  • Inspection method — whether the internal check is visual, profile gauge or both decides how the pipe leaves the line.

Questions buyers ask

Can one machine do both outside and inside?
They are usually two stations on one line rather than one head. Combining them in a single pass is possible on some diameters but it constrains the layout — worth discussing before the building is built.
What grade can be reached inside a pipe?
SA 2.5 and SA 3.0 are both achievable; the constraint is usually access and inspection at smaller diameters rather than the blast itself.
What do you need to quote?
Diameter range, wall thickness, length, coating standard, and the metres per shift you need to produce.

Related: roller conveyor machines for plate and profiles, which machine type fits your part.

Send the pipe schedule

Diameter range, wall, length and coating standard — we will lay out the line and the inspection point.

Get a quote

Related machines

Buyers weighing this machine usually compare it against these.