Rotary Table Shot Blasting Machine
The part sits on a table. The table turns. Blast wheels mounted above — and often at the side — cover it as it passes. Nothing falls, nothing collides with anything else, and the part is never lifted onto a hook.
The machine for parts that will not hang or tumble
There is a category of workpiece that breaks the other two options: too heavy to lift onto a hook, too big or too delicate to fall against its neighbours on a belt. Gearbox housings, large castings, weldments, machined frames, pump bodies. A rotary table takes them as they are — set down by crane or forklift, blasted in place, lifted off.
Because the part does not move relative to the table, the blast pattern repeats in the same place every revolution. That is either the point or the problem, depending on the part: flat panels need the wheels arranged so the pattern covers the whole face, while a part with deep recesses needs the wheels positioned to reach into them from more than one angle.
Where it stops making sense
A rotary table blasts one part at a time — or a few small parts spread across the table. If your throughput is measured in tonnes per shift of small castings, this is the wrong machine; a tumble belt loads 200 kg to a tonne per cycle and does it without an operator standing by. The table wins on size and handling, not on throughput per hour.
What sets the specification
- Table diameter and load — the largest part footprint and its weight, plus the crane capacity that puts it there.
- Part height — how far the wheels sit above the table, and whether side wheels are needed for vertical faces.
- Recesses and internal faces — whether the blast pattern reaches them by rotation alone, or needs angled wheels.
- Loading method — crane, forklift or a trolley that rolls the part in; this changes the door and the floor detail.
Typical configuration
| Table | Powered rotation with variable speed; diameter and load capacity set by the part |
| Wheels | Top-mounted as standard, side-mounted where vertical faces or recesses need coverage |
| Door | Sized to the loading method — crane access or trolley entry |
| Abrasive circuit | Elevator, separator and screw conveyor matched to the wheel count |
| Controls | Table rotation, wheel drives and dust extraction interlocked so the door cannot open under blast |
Table diameters and wheel arrangements are set per part — send the drawing and the lifting method and the layout follows from it.
Questions buyers ask
Related: hook type machines, which machine type fits your part.
Send the heaviest part you have
Footprint, weight, height and how it gets to the machine — that sets the table.
Get a quote